Easy-On II Terminations

More Information
	General Information
	Accessories
	Ordering Information

G&W's Easy-On II termination meets all industry requirements and is a Class I (outdoor) termination as defined in IEEE 48 standard for high voltage terminations. It contains a porcelain insulator and a factory-made elastomer stress relief for use on all synthetic insulated solid dielectric cables. The stress control elastomer is installed within the porcelain at the factory. Sizes are available for all shielded cables in voltage classes from 2kV through 34.5kV and conductor sizes through 1000 KCM.

Features:

The porcelain insulator has maximum resistance to moisture, industrial pollution and seacoast pollution. Porcelain is the most reliable insulator for use where insulator dry-band arcing may occur.

The termination interior dielectric system is the G&W spring loaded elastomer system. The spring force on the elastomer produces a strong dielectric interface along the cable and the porcelain bore; it prevents the ingress of water, and it accommodates the thermal expansion and contraction of the cable.

The G&W elastomer spring load system is the most reliable method to provide continuous mechanical force to the elastomer, thereby negating any elastomer permanent set.

The termination interior dielectric system contains a conductive elastomer stress relief cone.

All of the termination interior elastomer dielectric parts are factory assembled.

Termination field assembly is as easy as pulling the two pins releasing the elastomer compression spring. No tapes, tubes, nuts or bolts. No pushing or pulling or shrinking to fit.

The Easy-On II termination is used on jacketed concentric neutral, metal tape shielded or wire shielded cables without need for additional kits or tapes. The termination ground (or neutral) connection has the same ampacity as the cable shield (neutral system)

The Easy-On II terminations E5200, E5202 and E5203 are light enough to hang from a fuse cutout.

A full line of connectors is available for Easy-On II terminations for conductor sizes 6 AWG through 1000 KCM. Connector types include: pin type, 6 inch copper wire lead, eyebolt, in-line sleeve, aerial, flat bus and spade.

Physical Data
Catalog No.	Voltage Class (kV)	Bil (kV)	Conductor Range	Insulator Range	Dry Arc Dist. (In.)	Wet Leak Dist. (In.)	Max. Height (In.)	Dia. (In.)	Wt. (Lbs.)
E5200	15	110	6-300	.41-1.16	6.5	16.0	13.2	4.13	4.5
E5260	15	110	4/0-1000	.86-1.82	7.5	18.0	19.3	5.88	12.0
E5202	25	150	6-250	.41-1.16	11.5	27.5	17.4	4.13	7.5
E5265	25	150	4/0-1000	.86-1.82	7.5	18.0	19.3	5.88	12.0
E5203	34.5	200	6-2/0	.41-1.16	11.5	27.5	16.8	4.13	7.5
E5263	34.5	200	4/0-1000	.86-1.82	11.0	27.0	22.3	5.88	16.0

Notes:

All dimensions are in inches.
Conductor sizes are AWG and KCM.
Termination height excludes additional connectors such as the aerial connector or the flat pad bus connector.
Height does include pin connector such as TG-1 on the small Easy-On.

Field Assembly

Each G&W termination is complete with field assembly instructions. Only normal hand tools are required. The following is a summary of the field assembly.

Site Map