|
This specification covers the requirements
for a cable termination for (bracket) (flange) (equipment)
mounted installation. The termination shall be manufactured
by G&W Electric Company per product designation Slip-on
Terminator. The termination shall feature factory installed
stress relief and insulating material to reduce field installation
time. The termination manufacturer shall be ISO 9001:2000
certified.
A. APPLICATION
The termination shall be used on the following
cable type:
___ Extruded dielectric, concentric
neutral, jacketed or unjacketed.
___ Extruded dielectric, shielded,
jacketed including Unishield, wire and tape shielded.
___ Extruded dielectric, shielded, lead
jacketed.
___ Paper or varnished cambric, lead jacketed.
B. CONSTRUCTION
The termination shall use high strength,
wet process porcelain for external insulation. The porcelain
shall be a deep draw, corrugated design to permit upright
or inverted mounting, indoors or out. Factory installed, internal
stress relief devices shall provide electrical stress relief
without having to build a taped stress cone on the cable.
The terminations shall be factory filled with an insulating
material with a dielectric constant approximating that of
polyethylene. The insulating material shall create a void
free environment around the prepared cable end and permit
acceptance of a wide range of cable sizes. The terminations
shall use a rubber diaphragm seal at the cable entrance for
continuous sealing and the ability to accept a wide range
of cable diameters.
C. DESIGN RATINGS AND STANDARDS
Terminations shall be rated: (select column)
| Voltage class,
kV |
15 |
25 |
35 |
46 |
| Impulse level
(BIL), kV |
110 |
150 |
200 |
250 |
D. ACCESSORIES (check)
The following accessories shall be supplied:
___ Type K adapter kit.
___ Type W adapter kit.
___ Type PW adapter kit.
___ Eyebolt style aerial connection.
___ Hood style aerial connection.
___ Copper compression connector for eyebolt
design.
___ Aluminum compression connector for eyebolt
design.
___ Copper compression connector for hood
design.
___ Aluminum compression connector for hood
design.
___ Clamp type aerial lug.
___ Style 4 offset aerial lug.
___ Vertical flat pad aerial lug.
___ Style 8 offset flat pad aerial lug.
___ Mounting bracket.
|
